3
OPERATION
Removing a Clutch
1. Select the correct size spline sleeve. Place the spline
on the adapter shaft, then attach to the head plate
with the release pin & retaining pin provided.
2. Close the release valve by tightening the release
valve knob. Pump the handle to raise the lifting arm
and align the spline sleeve with the clutch.
3. Tilt the head plate with the tilt adjustment bolt to align
it with the clutch bore. Slide the spline sleeve into
the clutch.
4. Remove the clutch mounting bolts and back the jack
and clutch away from the flywheel.
Transporting the Clutch while on Jack
Be sure the adapter shaft is in the vertical position and
the jack is fully lowered before transporting, as shown
in Figure 2.
Loading and Unloading a Clutch from the Jack
1. To load or unload a clutch from the jack, be sure the
adapter shaft is in the vertical position, as shown in
Figure 2.
2. Add or remove one piece of the clutch at a time.
Installing a Clutch
1. Raise the clutch into the horizontal position for
installation and tilt the clutch using the tilt adjustment
bolt to align with the flywheel.
2. Put the jack and clutch into position so that the spline
shaft engages the pilot bearing in the flywheel. Install
and tighten the clutch mounting bolts.
BEFORE USE
1. Verify that the product and the application are
compatible, if in doubt call Omega Technical Service
(888) 332-6419.
2. Before using this product, read the operator's manual
completely and familiarize yourself thoroughly with
the product, its components and recognize the
potential hazards associated with its use.
3. Open the release valve by turning the release valve
knob counter-clockwise (no more than 1/2 full turn).
4. With lifting arm fully lowered, locate and remove the
oil filler plug. Pump handle 6 to 8 full strokes. Ensure
the oil level is within ~3/16" from the inner cylinder
as viewed from the oil filler hole. Reinstall the oil filler
plug. Close release valve by turning it clockwise until
firm resistance is felt.
5. Check to ensure that jack rolls freely, that the pump
and release valve operate smoothly. Raise and lower
the unloaded jack throughout the advertised lift range
before putting into service.
6. Replace worn or damaged parts and assemblies
with Factory Authorized Replacement Parts only.
Lubricate as instructed in Maintenance Section.
! WARNING
• Study, understand, and follow all printed materials
provided with/on this device before use.
•
Do not exceed rated capacity.
•
Use only on hard, level, seamless surface.
•
Do not allow any part of your body under the lift
arm or load while the jack is supporting a load.
•
Use only the factory supplied adapters as a
means of contacting the load. Never use any
other part of the jack as a lifting surface.
•
Use of this jack is limited to the removal,
installation and transportation of clutch/flywheel.
•
Adequately support the vehicle before starting
repairs.
•
Failure to heed these markings may result in
personal injury and/or property damage.
Be sure all tools and personnel are clear before
lowering load.
! WARNING
Figure 2 - Illustration of Lowest Position with Clutch
Adapter Shaft
Clutch
