2
Save these instructions. For your safety, read, understand, and follow the information provided with and on
this jack. The owner and operator of this equipment shall have an understanding of this jack and safe operating
procedures before attempting to use. The owner and operator shall be aware that use and repair of this product
may require special skills and knowledge. Instructions and safety information shall be conveyed in the operator's
native language before use of this jack is authorized. If any doubt exists as to the safe and proper use of this jack,
remove from service immediately. Inspect before each use. Do not use if broken, bent, cracked, or damaged parts
(including labels) are noted. Any jack that appears damaged in any way, operates abnormally or is missing parts,
shall be removed from service immediately. If the jack has been or suspected to have been subjected to a shock
load (a load dropped suddenly, unexpectedly upon it), immediately discontinue use until jack has been checked by
an Omega authorized service center. It is recommended that an annual inspection be done by qualified personnel.
Labels and Operator's Manuals are available from manufacturer.
PRODUCT DESCRIPTION
The Omega Hydraulic Clutch Jack is designed for clutch/ flywheel removal and installation. Intended use: to remove,
install and transport (in lowest position) both 14" and 15-1/2" clutches and flywheels. The two most common spline
sizes, 1-3/4" and 2" diameter, are included with this product. The head plate enables clutch to be positioned in either
horizontal position for clearing underneath vehicle or vertical position for installation and removal. The spline sleeve
rotates 360 degrees, turns side to side and vertically tilts for precise clutch alignment.
DO NOT USE FOR ANY PURPOSE OTHER THAN THOSE USES OUTLINED ABOVE !
Figure 1 - Model 40500 Components
SPECIFICATIONS
Model Capacity Jack Size (L x W )
Min.
Height
Max.
Height
Spline
Dia.
Shaft
Dia.
Volume of
Hyd. Oil
Net
Weight
40500 500 lb. 44 1/2" x 22 1/2" 16 1/2" 42" 1-3/4" & 2" 1" 6.6
OZ
/ 195
mL
145 lb.
Pump Handle
Lifting Arm
Rear Caster
Adapter Shaft
Spline Sleeve
Tilt Adjustment Bolt
Release Pin
Head Plate
Release Valve Knob
Front Caster
Horizonta
l Position
