User Manual for the NETGEAR RangeMax™ Wireless USB 2.0 Adapter WPN111
Basic Setup 3-9
202-10076-01
Install the NETGEAR RangeMax™ Wireless
USB 2.0 Adapter WPN111.
a. Locate an available USB port on your
PC. Connect the USB cable to the
WPN111 and insert the other end of the
cable into the USB slot on your PC.
b. After a short delay, the Found New
Hardware Wizard displays. The first
time that you install the WPN111 on a
computer, the wizard will install the
bootloader device. Follow the
installation prompts.
Note: Click Yes if you are prompted
with a Digital Signature Not Found
message.
c. After the bootloader device is installed,
the Found New Hardware Wizard will
display again and install the WPN111.
Follow the installation prompts.
Note: Click Yes if you are prompted
with a Digital Signature Not Found
message.
d. Click Finish when done, and if
prompted restart your computer.
a. You will see the WPN111 system tray
icon on the lower right portion of the
Windows task bar.
F ou nd N ew H ard wa re W iza rd
Note: If your computer does not have a U SB v2.0
p o rt b u t ra th e r a U S B v1 . 1 ty p e p ort, th e W P N 1 1 1
will be limited to the maximum speed of the USB
v1.1 port. USB v1.1 port maximum speed is 14
M bps whereas the maximum speed of a U SB v2.0
port is 480 M bps.
W P N 1 1 1 S ystem Tray Icon
