Signal modules
05/02 AWB2725-1452GB
10
Mounting the signal modules
X Insert the loop on the bottom of the module into the hole in the
module rack .
X Press the top of the module onto the module rack, until you
hear it click into position
.
Detaching the signal modules
X Press in the catch .
X Keep the catch pressed in and pull the top of the module
forwards
.
X Lift up the module and remove it .
Fixing the terminal block
X Plug the lower end of the terminal block onto the module board.
Screw in the fixing screw a short way .
X Push the top end of the terminal block onto the module, until
you hear it snap into position
.
X Hold the top end of the terminal block firmly, and tighten up the
fixing screw .
X Tug on the top end of the terminal block, to check that it is
firmly seated and cannot come loose .
Figure 6: Mounting the signal modules
Figure 7: Detaching the modules
1
2
2
1
1
2
3
1
2
3
Figure 8: Fixing the terminal block
1
2
3
4
1
2
3
