3-4
Fueling
It is very important to take special precautions to avoid spillage while fueling your boat.
Gasoline vapors are heavier than air and will develop in the lower cavities of the boat,
such as the bilge.
Below is a list of guidelines you should follow when fueling your boat:
1) Extinguish all cigarettes and other flame or spark producing items.
2) Make sure all power is off, and do not operate any electrical switches.
3) Be sure to wipe off any
spillage that may have
occurred.
4) Operate the bilge blower
for a minimum of four
minutes before starting
the engine.
Figure 3-5. Fueling
Starting
Starting procedures will vary depending on the type and model of engine installed in your
Malibu. Consult the engine owner’s manual for more specific information regarding
starting, operation, and troubleshooting for your particular engine.
Pay close attention to the information regarding the break-in period listed in your engine
owner’s manual. Top engine performance is dependent upon following the guidelines
listed.
Pre-Start Checklist
A routine pre-starting procedure should always be carried out before the first start-up of
the day. Below is a list of basic, necessary checks to perform before starting your engine.
1) Replace drain plugs.
2) Check oil and transmission fluid levels.
3) Check fuel supply.
4) Inspect the engine compartment for water or fuel leaks.
5) Operate bilge pump until bilge is dry.
6) Operate blower for a minimum of four minutes to expel fumes.
Starting the Engine
Please refer to your engine owner’s manual for the proper starting procedures.
KC-0991M
®
