
2-9
Switches & Indicators
Accessory Switch Panels
These panels are located in the dash directly below the standard gauges and are used to
activate the following features. You will find the feature or accessory provided within
each button face for description.
• Horn
• Navigation Lights
• Interior Lights
• Accessory Docking Lights
• Accessory Tower Lights
• Accessory Shower
• Accessory Heater
• Accessory Malibu Launch System (MLS)
• Accessory Stereo
• Bilge Pump
• Blower
Figure 2-11. Accessory Switch Panel
Bilge Pump
The bilge pump switch is used to activate the bilge pump so that any excess water in the
bilge area may be drained out. You should know that the bilge pump has a sensor in the
bilge area and will turn on automatically whenever two inches or more of water is detected.
Blower
This switch activates the blower for the engine compartment. The primary function of the
blower is to eliminate any fumes in the motor compartment when starting the engine or
during idling.
Gasoline Vapors Can Explode. Before starting engine, operate
blower for 4 minutes and check engine compartment for
gasoline leaks or vapors. Run Blower below cruising speed.
Stereo
This switch must be on for your stereo to have power. Please see the stereos owner’s
manual for operating instructions.
acc
Shower
acc
Tower
Light
acc
Docking
Lights
Int
Lights
Dash
Nav
Lights
Anc
Horn
Blower
Bilge
Pump
acc
Stereo
acc
fill
MLS
drn
acc
hi
heater
low
IGNITION SWITCH
PICK-UP
SPEEDO
GASOLINE VAPORS CAN EXPLODE. BEFORE STARTING ENGINE, OPERATE BLOWER 4 MIN. AND CHECK ENGINE COMPARTMENTS FOR
GASOLINE LEAKS OR VAPORS. RUN BLOWER BELOW CRUISING SPEED.
WARNING
MAL109-10