LiftMaster SL585 Manual

next previous

IMPORTANT NOTE: This operator is shipped from the factory as a right hand mounted unit, unit MUST be phased correctly. On three

phase operators, power connections must be properly phased. If phased incorrectly, the gate operator will run reversed. To correct this

situation, shut off power at main power source and at the operators electrical disconnect switch. Then reverse any two of the three

power leads.

AVAILABLE CONDUIT ACCESS FOR THE ELECTRICAL BOX

The accessory tray is equipped with several 1-1/2" pass though holes as well as 3/4" and 1" knock outs for conduit connectors. The

electrical box is equipped with 3/4" and 1" knock outs for conduit connectors.

ON/OFF SWITCH POWER WIRING

NOTES: Before running power wiring refer to wiring specifications on page 8 for correct wire gauges.

Secure all electrical power connections inside the disconnect switch electrical box. Refer to electrical wiring diagrams on pages 26-29.

115V SINGLE PHASE

POWER SWITCH ASSEMBLY

230V SINGLE PHASE &

THREE PHASE

POWER SWITCH ASSEMBLY

SINGLE PHASE

All single phase 115V/208/230V operators will have the

following:

• L1 WHITE

• L2 BLACK

• GROUND, GREEN

THREE PHASE

All three phase operators will have the following:

• L1 BLACK

• L2 BLACK

• L3 BLACK

• GROUND, GREEN

Pull the handle

to release

MODEL SL585

DISENGAGEMENT: Rotate disconnect handle 90˚ to

disengage. The gate may now be

moved manually.

RE-ENGAGEMENT: Rotate handle back to original

position. (Some operator output

sprocket rotation may be required for

engagement).

MODEL SL595

DISENGAGEMENT: Open the hinged door and pull the

disconnect lever and lock it in place.

The gate my now be moved manually.

RE-ENGAGEMENT: Release the lever and close the door.

(Some operator output sprocket

rotation may be required for

engagement).

MANUAL DISCONNECT