CONFIGURE
Edit Unit Settings - This area allows you to customize your tracking unit(s).
Select the activated Unit from the pull down menu.
For most users, you do not need to make any changes on this page except naming the unit.
Under Unit Name, type in a name for the vehicle, such as “Truck1” or “GMC1”.
Fleet#
If you have a large fleet you can use this feature to divide up your fleet.
Input Description
In the Input Description block enter the type of input conditions to be monitored such as Air
Bag or Car Alarm.
Output Descriptions
In the Output Descriptions, type in the output you intend to control, such as “Shut Off Engine”
or “Unlock Doors”.
Notification Paths
The Notification Path is the means you select for an event notifications to be sent. These
notifications may be received by e-mail or alphanumeric page. If notification is not selected you
can still view all alarms and conditions received from each Unit using the View Data Received
function. To use cell phone text messaging select e-mail and enter the text messaging e-mail
address into the primary or secondary e-mail address block. If you do not know the e-mail
format of your cellular phone we have provided a list under Documentation | E-mail addresses
for Cell Phones.
Input Notification Control
The Input Notification Control allows you to receive notification status (Alarms) for the inputs
set in the Input Description block. Select Yes for all inputs entered in the Input Description
block. Select Yes or No for normal/alarm conditions. Yes will allow you to receive notifications
for normal and alarm conditions.
Input Notification Text
The Input Notification Text will be the text received by you via e-mail or alphanumeric page
stating the conditions (Alarm/Normal) of the selected inputs. In the Alarm/Normal text blocks
type the condition or notification to be received via e-mail or alphanumeric page.
The Supply Voltage Alarm and Supply Voltage Normal is intended for use with a supply that
has a backup battery. Upon completion click Update.
List Units
This function gives you a list of all the units in your fleet. It will also show you when the unit
was activated and the last time the units have sent data.
