Operating Instructions - Squaring the Fence
7.
Squaring the Fence
The squaring fence serves as a general reference to keep your
workpieces aligned prior to assembly. It comes calibrated from the
factory with a basic carpenters square. It should be noted that
the most important aspect of making sure your frames turn out
square and flush is by assuring that your workpieces are cut square
and true prior to assembly. Simply put, if your workpieces are not
square prior to assembly, your frame will not be square once
assembled. The squaring fence features set screws that allow
it to be easily re-calibrated if knocked out of alignment.
To re-align squaring fence:
1) Place carpenter’s square on base of table
2) Loosen locking nuts
3) Adjust allen screw inward or outward to re-square fence
4) Re-tighten locking nut
Figure 2
Figure 3
Figure 4
Figure 1
Loosen locking nuts with hex wrench, and adjust the set screws
with an allen wrench to square fence.
Re-tighten locking nut once complete.
4-
Place carpenter’s square on base of table and check for gap.
Adjusting the set screw.
