DMC 1000 Digital Media Camcorder User’s Guide (v1.15) 79
Chapter 6 - Audio setup
Chapter 6
Audio setup
6.1 Introduction
Audio signals from various sources can be recorded onto four audio recording channels. These
channels are identified in the menus as:
•ch1
•ch2
•ch3
•ch4
The sources used for recording can be:
• the front microphone,
• the line or mic. inputs at the rear of the camcorder,
• AES digital audio signals applied to the BNC input at the right-rear of the camcorder,
• one of eight embedded SDI audio channels, or
• an optional wireless microphone receiver.
Audio signals are output:
• on the rear 5-pin XLR audio output connector,
• as embedded channels in the SDI output signal, or
• as AES digital audio signals on the BNC connector on the right-rear of the camcorder.
The following pages will tell you how to:
• connect the inputs and set input sensitivity,
• select recording channel sources and set recording levels,
• monitor channels and sources, and
• select output channels or sources.
