I
-
I
-
Using Spectrum Analyzer Features
Saving and Recalling Data from the Memory Card
To
Recall
Limit-Line
lhbles
or
Amplitude
Correction
Factors
1. Use Change Prefix to enter the prefix, or use the existing prefix.
2.
press
[RECALL_).
If INTERNAL is underlined, press INTERNAL CARD to
select CARD.
3. Press Card -+ Trace to access the menu with LIMIT LINES and
AMP COR.
4.
Press either LIMIT LINES , to recall a limit-line table, or AMP COR , to
recall amplitude-correction factors.
5. Enter the register number that the limit-line data or amplitude-correction
factors was saved under and then press
CENTER).
NOTE
If LOAD FILE is used to recall limit-line files or amplitude-correction factor files, the traces are
set to the store-blank mode. Press
Cm),
CLEAR WRITE A to view trace A data, or press
(PRESET).
3-27
