23
Section 4.0 — System Alarms / Troubleshooting
4.7 Alarm Codes Description Chart
Check alarm code values that you recorded on the opposite page with the list of alarm code descriptions below. Enter the
description in the appropriate column on the Alarm Codes Recording Chart (opposite page).
TAKE
LEDs SLOW BLINKING LEDs FAST BLINKING
SYNC
Detected multiple handles with the same handle ID at startup.
Combined battery input below 9V for 12V or 18V for 24V systems.
No handle connected at startup.
Handle #1 PORT potentiometer reading below 0.25V or above 4.75V.
Handle #2 PORT potentiometer reading below 0.25V or above 4.75V.
Handle #3 PORT potentiometer reading below 0.25V or above 4.75V.
Handle #4 PORT potentiometer reading below 0.25V or above 4.75V.
Handle #5 PORT potentiometer reading below 0.25V or above 4.75V.
Handle #6 PORT potentiometer reading below 0.25V or above 4.75V.
Handle #1 STBD potentiometer reading below 0.25V or above 4.75V.
Handle #2 STBD potentiometer reading below 0.25V or above 4.75V.
Handle #3 STBD potentiometer reading below 0.25V or above 4.75V.
Handle #4 STBD potentiometer reading below 0.25V or above 4.75V.
Handle #5 STBD potentiometer reading below 0.25V or above 4.75V.
Handle #6 STBD potentiometer reading below 0.25V or above 4.75V.
**CP lost communication with Handle #1.
**CP lost communication with Handle #2.
**CP lost communication with Handle #3.
**CP lost communication with Handle #4.
**CP lost communication with Handle #5.
**CP lost communication with Handle #6 (will not be stored).
** = Handle loosing communication will cause an alarm condition if handle is the active handle at time of fault
WARM TROLL TAKE SYNC WARM TROLL
ALARM CODE
DESCRIPTION
