Installation Instructions
STEP 16 DISHWASHER WET TEST
■
Turn on power supply (or plug power cord into outlet,
Turn on power supply (or plug power cord into outlet,
■
Start the unit to check for leaks.
Start the unit to check for leaks.
– Press ON/OFF button to turn unit on
– Press CYCLE SELECT button until light below RINSE cycle
■
■
Check to be sure that water enters the dishwasher. If water
Check to be sure that water enters the dishwasher. If water
does not enter the dishwasher, check to be sure that water
■
Check for leaks under the dishwasher. If a leak is found, turn
Check for leaks under the dishwasher. If a leak is found, turn
off power supply, then tighten connections. Restore power
■
Check for leaks around the door. A leak around the door
Check for leaks around the door. A leak around the door
could be caused by door rubbing or hitting against
adjacent cabinet. Reposition the dishwasher if necessary.
■
The dishwasher will drain and turn off about 5 to 7 minutes
The dishwasher will drain and turn off about 5 to 7 minutes
after the first fill. Check drain lines. If leaks are found,
turn power off at the breaker and correct plumbing as
necessary. Restore power after corrections are made. See
■
Open dishwasher door and make sure most of the water
Open dishwasher door and make sure most of the water
has drained. If not, check that disposer plug has been
removed and/or air gap is not plugged. See Step 13. Also
check drain line for kinking.
■
Run the dishwasher through another fill and drain cycle.
Run the dishwasher through another fill and drain cycle.
Check for leaks and correct if required.
■
At the end of drain, open door and press ON/OFF button to
At the end of drain, open door and press ON/OFF button to
• Place 2-piece toekick against the legs of the dishwasher.
• Place the inner toekick piece (with slots) against the toekick
bracket. The slots should align with toekick bracket screw
holes. Allow the toekick to touch the fl oor.
• Place larger toekick over the inner piece and install 4 toekick
• Use additional 2 screws for installations over 33-1/2" high.
• Use both toekick pieces for all installation heights.
• Be sure to leave complete literature package and Installation
Instructions with the consumer.
Louisville, Kentucky 40225
© 2005 General Electric Company
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE
2-Piece Toekic
k
Adjust Up
or Down
Use Top 4
Screw Holes
