Installation Instructions
STEP 12 CONNECT WATER SUPPLY
Connect water supply line to 90° elbow.
• Insert water line into 90°
STEP 13 CONNECT DRAIN LINE
FOLLOW ALL LOCAL CODES AND ORDINANCES.
The molded end of the drain hose will fit 5/8" through 1"
diameter inlet ports on the air gap, waste tee or disposer.
• Determine size of inlet port
• Cut drain hose connector on the marked line, if required, to fi t
• If a longer drain hose is required, add up to 42" of length for
a total of 10' to the factory installed hose. Use 5/8" or 7/8"
inside diameter hose and a coupler to
• Secure the drain hose to the air gap, waste tee or disposer
TOTAL DRAIN HOSE LENGTH MUST NOT EXCEED 10' FOR
Method 2 – Drain Hose Routing
Route the drain hose of the dishwasher to a minimum height of 32" from
the fl oor with the supplied hanger as shown.
drain line to disposer, check to be sure
that drain plug has been removed.
DISHWASHER WILL NOT DRAIN IF
Avoid unnecessary service call charges. Always be sure
disposer drain plug has been removed before attaching
dishwasher drain hose to the disposer.
18"
Min.
32"
Min.
05A-1183GG
Fasten drain hose at least at
32" height with hanger supplied
Either one of the above methods
Method 1 – Air gap with waste tee or disposer
Insert the drain hose to air gap
32"
Min.
18"
Min.
05A-1183FF
Fasten drain hose at least at
32" height with hanger supplied
– Check to be sure that door spring does
not rub or contact the fill hose or water supply line. Test by
opening and closing the door. Re-route the lines if a rubbing
noise or interference occurs.
• Connect drain line to air gap, waste tee or disposer using
either previously determined method.
9
Ferrule
90° Elbow
Compression Nu
t
Hot Water
Supply Line
10
Cutting Lines
1"
3/4"
5/8"
IMPORTANT: Do not cut corrugated
portion of hose
