For standpipe or laundry tub drain systems:
• Open yellow, single-wire clamp with pliers and
slide over hooked end of drain hose to secure the
rubber and corrugated sections together.
• Put hooked end of drain hose into laundry tub or
standpipe. Rotate hook to eliminate kinks in the hose.
To prevent drain water from going back into the washer:
• Do not straighten hooked end of drain hose. Do not
force excess drain hose into standpipe. Hose should
be secure, but loose enough to provide a gap of air.
• Do not lay excess drain hose in bottom of laundry tub.
CONNECT DRAIN HOSE (cont.)
2
Installation Instructions
• Insert new flat washers (supplied) into each end
of the inlet hoses. Firmly seat the washers in the
couplings.
Connect the inlet hoses to the water faucets
Make sure the washer basket is empty.
• Attach the hose with the red coupling to the hot
water faucet. Screw on coupling by hand until seated
on the washer.
• Attach the hose with the blue coupling to the cold
water faucet. Screw on coupling by hand until seated
on the washer.
• Using pliers, tighten the couplings with an
additional two-thirds turn.
NOTE: Do not overtighten. Damage to the valves
can result.
Clear the water lines
• Run water through both faucets and inlet hoses, into
a bucket or laundry tub, to get rid of particles in the
water lines that might clog the inlet valve screens.
CONNECT INLET HOSES
3
11
Drain hose
Hooked end
Washer
Coupling
