486
Chapter 30 I/O Ports
3.Port Register Settings
Remark: This pin supports external interrupt wake up from STOP-HIZ mode. Because of this
the internal input line is not forced to low in STOP-HIZ mode if the PFR is set to ‘1’ and
interrupt is enabled with ENIR0.EN2 set to ‘1’.
PFR24.1 0 - Port is in general purpose port mode.
1 - Port is in resource function mode:
Resource function is INT1 input
Remark: This pin supports external interrupt wake up from STOP-HIZ mode. Because of this
the internal input line is not forced to low in STOP-HIZ mode if the PFR is set to ‘1’ and
interrupt is enabled with ENIR0.EN1 set to ‘1’.
PFR24.0 0 - Port is in general purpose port mode.
1 - Port is in resource function mode:
Resource function is INT0 input
Remark: This pin supports external interrupt wake up from STOP-HIZ mode. Because of this
the internal input line is not forced to low in STOP-HIZ mode if the PFR is set to ‘1’ and
interrupt is enabled with ENIR0.EN0 set to ‘1’.
Remark: It is generally possible to use input only resource functions (like e.g. INT, ICU, CAN.RX, UART.SIN)
also in the Port I/O input mode (PFR=’0’ and DDR=’0’). In that case the internal input line is forced to low in
STOP-HIZ mode.
