For instructions on how to activate the auto tear-off function, see
“Using the Default-Setting Mode” in Chapter 4 or open the
EPSON Remote! utility as described in Chapter 2 and follow the
on-screen instructions. While using the default-setting mode or the
utility, also make sure the page length is set correctly for your
continuous paper. If you make these settings in the default-setting
mode, be sure to turn off the printer then turn it on again to apply
your settings.
The steps below describe how to use auto tear-off.
1. When you finish printing on continuous paper, the printer
advances the perforation of the final printed page to the
tear-off position.
2. Tear off all printed pages. (If the perforation is not aligned with
the tear-off edge, you can adjust the tear-off position using the
micro-adjust feature. See “Adjusting the tear-off position” later
in this chapter.)
3. When you resume printing, the printer automatically feeds the
paper back to the top-of-form position and begins printing.
(You can also manually feed the paper back to the top-of-form
position by pressing the
Tear Off/Bin
button.)
You can leave auto tear-off mode on even when you are using
single sheets because the mode is disabled when you move the
paper release lever to the single-sheet position.
3
R
Adonis Rev.E
A5 size Chapter 3
97/04/07 pass 0
Paper Handling
3-19
