A SERVICE OF

logo

Connecting the Printer to Your Macintosh
There are two ways to connect the printer to your Macintosh,
using the printer’s built-in serial interface or using an optional
interface card.
Using the built-in serial interface
To use the printer’s built-in serial interface, you will need
an Apple System Peripheral-8 cable. Read the following steps
to connect the printer to your Macintosh.
1. Make sure both your printer and Macintosh are switched off.
2. Connect one end of the interface cable to the serial connector
on the back of the printer.
3. Connect the other end of the interface cable to either the
modem port or printer port on the Macintosh. The ports are
marked with the following icons.
e32
modem port
printer port
em-17,18
L
Easter10 Ref. Guide
Rev.C
A5 size Chapter 2
1-07-98 DR, pass 3
2-26
Getting Started