A SERVICE OF

logo

Rear Tail, Stop, Turn Signal, Side Marker and
Backup Lamps
1. Raise the liftgate.
2. Remove the tail lamp assembly by removing the two
screws from the inboard side. Use a fiber stick or similar
tool to gently pry the light on the outboard side to
disengage the two ball studs.
NOTE:
If a screwdriver is used, make sure a soft material is
placed between the vehicle body and tool so not to
scratch the paint.
The PRY location is best closest to the studs while
dislodging them separately.
Removing Tail Lamp Assembly
478 MAINTAINING YOUR VEHICLE