A SERVICE OF

logo

Open as PDF
next previous
Replacing the Speakers
1. Follow the instructions in Preparing to Work Inside the Computer.
2. Follow the instructions in Removing the Speakers.
3. Place each of the new speakers in the appropriate speaker slot.
4. Replace the three M2.5 x 5-mm screws to secure the speakers to the base of the computer.
5. Connect the speaker cable to the system board.
6. Replace the palmrest (see Replacing the Palm Rest).
7. Replace the microprocessor thermal-cooling assembly (see Replacing the Microprocessor Thermal- Cooling Assembly).
8. Replace the display assembly (see Replacing the Display Assembly).
9. Replace the keyboard (see Replacing the Keyboard).
10. Replace the hinge cover (see Replacing the Hinge Cover).
11. Replace the optical drive (see Replacing the Optical Drive).
Back to Contents Page
1
speakers (2)
3
speaker cable
5
guide post slots (4)
2
M2.5 x 5-mm screws (3)
4
speaker connector
CAUTION: Before you perform any of the procedures in this section, follow the safety instructions in the Product Information Guide.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such as the
back panel) on the computer.
NOTICE: Exercise care when handling or replacing the speakers.
NOTE: For proper placement, align the slots on the speakers with the screw-hole guide posts on the base of the computer.