A SERVICE OF

logo

9. Turn the computer over and remove the four M2.5 x 5-mm screws securing the top of the palm rest.
10. Disconnect the touch pad cable.
Use a plastic scribe to release the locking clips on both sides of the system board connector, and then gently pull to disconnect the touch pad connector from the
system board connector.
11. Disconnect the LED board cable.
Use a plastic scribe to release the locking clips on both sides of the system board connector, and then gently pull to disconnect the LED board connector from the
system board connector.
12. Moving from left to right, carefully lift the palm rest along the rear edge, near the hinge brackets, then rotate the palmrest forward to remove it from the
computer.
1
M2.5 x 8-mm screws (11)
NOTICE: Release the locking tabs on both sides of the system board connector before attempting to remove the touch pad or LED cable. Failure to release the
locking tabs could result in damage to the cable and/or the cable connector.
1
M2.5 x 5-mm screws (4)
3
locking clips
5
touch pad connector
2
LED board connector
4
palm rest