Dell GX1 P Manual

A SERVICE OF

next previous

Installing Drives 7-9

)LJXUH$WWDFKLQJ'LVNHW WH'ULYHRU7DSH'ULYH&DEOHV

 )RUDQ(,'(WDSHGULYHRU&'520GULYHFRQQHFWWKHRWKHUHQGRIWKH

LQWHUIDFHFDEOHWRW KHLQWHUIDF HFRQQHFWRUODEHOHG´,'(µRQWKHV\VWHP

ERDUG

For a diskette drive or non-EIDE tape drive, connect the cable from the drive to

the interface connector labeled “DSKT” on the system board.

For a drive that comes with its own controller card, connect the other end of the

interface cable to the controller card.

Check all cable connections. Fold cables out of the way to provide airflow for the

fan and cooling vents.

 ,IWKHLQFKGULYHED\ZDVSUHYLRXVO\HPSW\ UHPRYHWKHIURQWSDQHO

LQVHUWIURPW KHIURQWEH]HO

See “Removing and Replacing Front-Panel Inserts” found earlier in this chapter.

 5HSODFHWKHIURQWEH]HO

 5HSODFHWKHFRPSXWHUFRYHUUHFRQQHFW \ RXUFRPSXWHUDQGSHULSKHUDOV

WRDQHOHF WULFDORXWOHWDQGWXUQW KHPRQ

NOTE: After you remove and replace the cover, the chassis intrusion detector will

cause the following message to be displayed at the next system start-up:

ALERT! Cover was previously removed.

diskette/tape drive

interface cable

DC power cable

interface connector

power input connector