4. Check for the required dependencies for the openwsman and sfcbd RPMs listed in the following
table.
Table 3. Required Dependencies
Packages Red Hat Enterprise Server SUSE Linux Enterprise Server
Openwsman OpenSSL
LibXML
Pkgconfig
CURL
Chkconfig
Initscript
SBLIM-SFCC
LibOpenSSL
LibXML
Pkg-config
libCURL
aaa_base
aaa_base
SBLIM-SFCC
SBLIM SFCC CURL LibCURL
SBLIM SFCB zlib
CURL
PAM
OpenSSL
Chkconfig
Initscript
zlib
LibCURL
PAM
LibOpenSSL
aaa_base
aaa_base
5. Install the dependent RPMs. You can install the RPMs:
– with a single command rpm -ivh rpm1 rpm2 rpm3 rpm4 … rpmN
or
– individually
NOTE: If you are installing RPMs individually, follow this sequence.
rpm -ivh sblim-sfcb-x.x.x.rpm
rpm -ivh sblim-sfcc-x.x.x.rpm
NOTE: Install the libwsman and openwsman client RPMs simultaneously as they have cyclic
dependency.
rpm -ivh libwsman1-x.x.x.rpm openwsman-client-x.x.x.rpm
rpm -ivh openwsman-server-x.x.x.rpm
Post Installation Configuration For Remote Enablement
This section details the steps to configure the dependent RPMs if you have installed the Remote
Enablement feature.
The post-installation configuration script is available at /opt/dell/srvadmin/etc/ on the server file system.
After installing all the dependent RPMs and the Remote Enablement feature, execute the
autoconf_cim_component.sh script.
NOTE: The Distributed Web Server (DWS) connection does not work properly, if you have installed
the sblim-sfcb RPM from SUSE Linux Enterprise Server 11 SP3 operating system DVD. To resolve
the connection issue, you must install the sblim-sfcb RPM either from SUSE Linux Enterprise Server
11 SP2 operating system DVD or from the Systems Management Tools and Documentation DVD.
Before executing the autoconf_cim_component.sh script, make sure that Systems Management is
installed.
16
