two connectors for line-in/ microphone and line-out;
two front-panel connectors for headphones and
microphone
10-pin header for optional media card reader (3.5-
inch bay device)
12-pin connector for optional second serial port card
If you are running Microsoft®Windows®XP, brings
up the Windows Security window; in MS-DOS®mode,
restarts (reboots) the computer
<F2> or <Ctrl><Alt><Enter>
starts embedded system setup (during system start-
up only)
automatically starts the computer from the network
environment specified by the remote boot
environment (PXE) rather than from one of the
devices in the system setup Boot Sequence option
(during system start-up only)
displays a boot device menu that allows the user to
enter a device for a single boot (during system start-
up only) as well as options to run hard-drive and
system diagnostics
green light — blinking green indicates a sleep mode;
solid green indicates a power-on state.
amber light — blinking amber indicates a problem
with an installed device; solid amber indicates an
internal power problem (see Power Problems).
solid green light indicates network connection
Link integrity light (on integrated network adapter)
green light for 10-Mb operation; orange light for 100-
Mb operation; yellow light for a 1000-Mb (1-Gb)
operation
Activity light (on integrated network adapter)
Four lights on the front panel. See Diagnostic Lights.
AUX_PWR on the system board
NOTE: Power consumption can be zero when the
computer is unplugged.
955 BTU/hr
NOTE: Heat dissipation is calculated based upon the
power supply rating.
manual selection power supplies — 90 to 135 V at
50/60Hz;180to265Vat50/60Hz
3-V CR2032 lithium coin cell
