A SERVICE OF

logo

8. Attach the SATA connector removed in step5 to the first hard drive.
9. Locate an unused SATA connector on the system board and attach a data cable to this connector and to the second hard drive.
10. Replace the computer cover (see Replacing the Computer Cover).
Drive-Panel Inserts
If you are installing a new floppy or optical drive instead of replacing a drive, remove the drive-panel inserts.
1. Follow the procedures in Before You Begin.
2. Remove the drive panel by sliding the drive release latch downward to open the panel. Then remove it from the hinges.
1
data cable
2
hard-drive system board connector
3
power cable