1. Remove the bezel (see "Removing the Bezel").
2. If your replacement hard drive does not have a carrier, install the new drive on a carrier (see "Installing a Hard Drive on a Carrier").
3. Open the hard-drive carrier handle (see Figure4-18).
4. Insert the hard-drive carrier into the drive bay (see Figure4-18).
5. Close the hard-drive carrier handle to lock it in place.
6. Replace the bezel (see "Replacing the Bezel").
7. Install any required SCSI device drivers (see "Installing and Configuring SCSI Drivers" in the User's Guide for information).
8. If the hard drive is new, run the SCSI controllers test in system diagnostics.
Removing a Hard Drive From Its Carrier
1. Remove the hard drive from the system (see "Removing a Hard Drive").
2. Remove the four screws that secure the drive to the carrier (see Figure4-19).
3. Remove the hard drive from the carrier.
Figure 4-19. Removing a Hard Drive From its Carrier
Installing a Hard Drive on a Carrier
1. Insert the replacement hard drive into the carrier (see Figure4-19).
2. Install the four screws that secure the drive to the carrier.
3. Install the hard drive in the system (see "Installing a Hard Drive").
Integrated RAID Controller
To activate the integrated RAID controller, you must install three components, the RAID controller memory module, hardware key, and battery.
Activating the Integrated RAID Controller