-28-
Revision 4/F3591 © Moffat Ltd, August 2004
1) Open the oven doors.
2) Remove the screws on the sides, top and
bottom edges of the door with the broken
glass.
NOTE:
If it is the left hand door, remove the
extra screws and ball catches.
6.3.18 DOOR GLASS
6.3.19 DOOR BALL CATCH
1) Remove the bottom lintel from the oven
(refer 6.2.5).
2) Undo both turnbuckles from the door chain
assembly.
6.3.20 DOOR LINKAGE CHAIN ASSEMBLY
3) Undo the two screws securing the
microswitch to the microswitch bracket.
4) Replace and reassemble in reverse order.
5) Adjust microswitch (refer 6.4.7)
3) Remove the two screws on the door front.
4) Lift off the door outer, making sure that
glass spacer and undamaged glass pane
do not fall out.
5) Remove all glass fragments, the glass
spacer and the undamaged pane.
NOTE:
The seals on the door inner and outer
must be replaced with new ones if
damaged.
6) Replace the broken pane and refit both
clean panes either side of the spacer.
7) Reassemble in reverse order.
Figure 6.3.26
Figure 6.3.30
Turnbuckle
1) Open oven door.
2) Loosen the locknut securing the ball
catch, and unscrew the ball catch.
Figure 6.4.27
4) Replace and reassemble in reverse order.
Figure 6.4.28
Locknut
Ball
catch
NOTE: The door striker plates should also
be checked for wear and replaced if
necessary.
Figure 6.4.29
Striker
Plate
Screws
(x6)
