-16-
Revision 4/F3591 © Moffat Ltd, August 2004
FAULT POSSIBLE CAUSE REMEDY
SLOW RECOVERY Oven in ‘Roast ‘n Hold’ mode.
Overloading of oven.
Fan not working.
One or more elements are
faulty.
Thermostat out of calibration.
(Refer fault diagnosis 6.1.10)
Contactor faulty
(Refer fault diagnosis 6.1.10)
Switch off ‘Roast ‘n Hold’.
Reduce oven loading.
Check fan operation.
Replace element.
(Refer service section 6.3.13)
Correct calibration.
(Refer service section 6.4.3)
Replace.
(Refer service section 6.3.12)
NO THERMOSTAT HEATING
INDICATOR
Indicator faulty.
Replace.
(Refer service section 6.3.4)
ROAST TIMER (180 MINUTE)
WILL NOT TIME DOWN
NO HOLD INDICATOR
HOLDING TEMPERATURE
INCORRECT
Roast ’n’ Hold switch not
switched on.
No power to timer / timer faulty.
(Refer fault diagnosis 6.1.11)
‘Roast ‘n Hold’ switch faulty.
(Refer fault diagnosis 6.1.11)
Faulty indicator.
(Refer fault diagnosis 6.1.12)
Faulty timer.
(Refer fault diagnosis 6.1.12)
Hold thermostat set
temperature incorrect.
Hold thermostat faulty.
(Refer fault diagnosis 6.1.13)
Turn on switch. Switch will
illuminate.
Correct electrical fault / replace
timer.
(Refer service section 6.3.7)
Replace.
(Refer service section 6.3.1)
Replace.
(Refer service section 6.3.3)
Replace.
(Refer service section 6.3.7)
Adjust to correct temperature.
(Refer service section 6.4.4)
Replace.
(Refer service section 6.3.9)
DOORS DO NOT CLOSE Tray in way of door.
Door catch setting incorrect.
Door chain setting incorrect.
Correctly position tray in rack.
Adjust.
(Refer service section 6.4.2)
Adjust.
(Refer service section 6.4.1)
