Chapter 4: Configuration
724-746-5500 | blackbox.com
Page 21
4.2.6 Miscellaneous functions
4.2.6.1 To reset configuration to factory defaults
1 Enter the Configuration menu.
2 Press to enter the Functions menu
3 Press and then . The display will show momentarily.
4 Press and then to exit the menu and save changes.
4.2.6.2 To show the current firmware version
1 Enter the Configuration menu.
2 Press to enter the Functions menu
3 Press and then .
The display will blank for a short while and then the major number of the firmware revision will be shown. The display will
blank again and then show the first digit of the minor number. Following another blank, the second digit of the minor number
will be displayed. e.g. <blank> 1 <blank> 0 <blank> 2 <blank> equals v1.02
4 Press and then to exit the menu and save changes.
4.2.6.3 To set a new password
1 Enter the Configuration menu.
2 Press
and then . The display will show
3 Enter a new password and then . See 5.1.4 Locking access to the computers
4 Press and then to exit the menu and save changes.
