SERVSELECT IP VM INSTALLER/USER GUIDE
32
4. Click OK to save the change, or click X or press Escape to exit without saving the
change.
Setting appliance security
You can enable a screen saver to start if the user remains unused for a specified length of
time. When the screen saver starts, the user is disconnected from any target device to
which it was connected. The screen saver stops when you press any key or move the
mouse.
To immediately start the screen saver, press Print Screen and press Pause.
If you set a password, the keyboard and mouse are locked when the screen saver starts.
When you press a key or move the mouse while the screen saver is running, a Password
window opens, and you must type the password and click OK to unlock the keyboard and
mouse.
Important: If you forget the password, you must call technical support. See “Appendix
D” beginning on page 51 for contact information.
To enable the screen saver, complete the following steps:
1. Press Print Screen. The Main window opens.
2. Click Setup > Security. If a password is set, the Password window opens. Type the
password and click OK.
3. Select the Enable Screen Saver check box.
4. In the Inactivity Time field, type the number of seconds (1 through 99) that must
elapse before the screen saver starts.
5. If the monitor is Energy Star compliant, select Energy; otherwise, select Screen.
6. (Optional) To run the screen-saver test, click Test. The screen-saver test runs for 10
seconds.
7. Click OK.
To disable the screen saver, complete the following steps:
1. Press Print Screen. The Main window opens.
2. Click Setup > Security. If a password is set, the Password window opens. Type the
password and click OK.
3. Clear the Enable Screen Saver check box.
4. Click OK.
A password must contain both alphabetic and numeric characters and can be up to 12
characters long. Passwords are case-sensitive. Valid characters are A through Z, a through
z, 0 through 9, space, and hyphen.
To set or change a password, complete the following steps:
1. Press Print Screen. The Main window opens.
2. Click Setup > Security. If a password is already set, the Password window opens.
Type the password and click OK.
3. Double-click the New field.
4. In the New field, type the new password.
5. In the Repeat field, type the password again.
6. Click OK.
