CHAPTER 3: INSTALLATION
15
To connect an SAM to each server:
1. Locate the SAM for your ServSelect II unit.
2. Attach the appropriately color-coded cable ends to the keyboard, monitor and
mouse ports on the fi rst server you will be connecting to the unit.
3. Attach one end of the CAT 5 cabling that will run between your SAM and
ServSelect II unit to the RJ45 connector on the SAM.
4. Connect the other end of the CAT 5 cable to the desired ARI port on the back
of your ServSelect II unit.
5. Repeat steps 2-4 for all servers you wish to attach.
NOTE:
When connecting a Sun SAM, you must use a multi-sync monitor to accommodate Sun computers
that support both VGA and sync-on-green or composite sync.
To connect local peripherals:
1. Select the keyboard, monitor and mouse to be connected to local analog user A.
2. Locate the port set labeled A on the back of the appliance. Connect these
peripherals to their respective ports.
3. Repeat these steps for the local analog port set labeled B.
4. Bundle and label the cables for easy identifi cation.
3.4 Setting Up Your ServSelect II System
With the ServSelect II system, you can auto detect and configure each port on your
appliance. Chapter 4 provides detailed instructions on naming, customization and
OSD setup and configuration.
