Express Ethernet Switch
13
?? Select a port
?? [ENTER]
?? Select the media from the list that appears on the screen
?? Continue with any further ports
The following table is an example of options:
Table 2: TX Port Settings
#
Communication
Media
Description
0 Flow Control Toggles ON/OFF
1 Auto Auto-Negotiation
2 100 FL 100Mbps at full-duplex
3 100 HF 100Mbps at half-duplex
4 10 FL 10Mbps at full-duplex
5 10 HF 10Mbps at half-duplex
Media Setting Example:
?? Key [M] (NO [ENTER])
?? Select port 10
?? Select mode 5
Hit the [ESC] key when done. To return to the default settings, enter [D]. A prompt appears
to verify this command since all options will revert to default mode, not just the media
settings. The following is the screen display of the above example.
Figure 6: Console port displaying mode change
Fiber Module Installation
?? Turn off the power. The module is not hot- swappable.
-----------------
V1 1,2,3,4,5,6,7,8,9,10,11,12,13,14,15,16,17,18,19,20,21,22,23,24
V2 <empty>
V3 <empty>
V4 <empty>
Port Mode Flw VLAN List Port Mode Flw VLAN List
1 Auto On V1 7 Auto On V1
2 Auto On V1 8 Auto On V1
3 Auto On V1 9 Auto On V1
4 Auto On V1 10 10HF On V1
5 Auto On V1 11 Auto On V1
6 Auto On V1 12 Auto On V1
