ARMING CHARACTER SWITCH POSITIONS
LSB MSB
ASCII CTRL HEX DECIMAL 1 2 3 4 5 6 7 8
DF 223 ON ON ON ON ON OFF ON ON
E0 224 OFF OFF OFF OFF OFF ON ON ON
E1 225 ON OFF OFF OFF OFF ON ON ON
E2 226 OFF ON OFF OFF OFF ON ON ON
E3 227 ON ON OFF OFF OFF ON ON ON
E4 228 OFF OFF ON OFF OFF ON ON ON
E5 229 ON OFF ON OFF OFF ON ON ON
E6 230 OFF ON ON OFF OFF ON ON ON
E7 231 ON ON ON OFF OFF ON ON ON
E8 232 OFF OFF OFF ON OFF ON ON ON
E9 233 ON OFF OFF ON OFF ON ON ON
EA 234 OFF ON OFF ON OFF ON ON ON
EB 235 ON ON OFF ON OFF ON ON ON
EC 236 OFF OFF ON ON OFF ON ON ON
ED 237 ON OFF ON ON OFF ON ON ON
EE 238 OFF ON ON ON OFF ON ON ON
EF 239 ON ON ON ON OFF ON ON ON
F0 240 OFF OFF OFF OFF ON ON ON ON
F1 241 ON OFF OFF OFF ON ON ON ON
F2 242 OFF ON OFF OFF ON ON ON ON
F3 243 ON ON OFF OFF ON ON ON ON
F4 244 OFF OFF ON OFF ON ON ON ON
F5 245 ON OFF ON OFF ON ON ON ON
F6 246 OFF ON ON OFF ON ON ON ON
F7 247 ON ON ON OFF ON ON ON ON
F8 248 OFF OFF OFF ON ON ON ON ON
F9 249 ON OFF OFF ON ON ON ON ON
FA 250 OFF ON OFF ON ON ON ON ON
FB 251 ON ON OFF ON ON ON ON ON
FC 252 OFF OFF ON ON ON ON ON ON
FD 253 ON OFF ON ON ON ON ON ON
FE 254 OFF ON ON ON ON ON ON ON
FF 255 ON ON ON ON ON ON ON ON
3.7Setting Global Characteristics with the
Individual Banks
Several other system-wide options are specified not
by the system switch banks, but rather by the eighth
switch position of the individual port switch banks.
Explanations and tables are given below.
Self-Test Function
NOTE
We recommend that you run software
flow control from your application
during self-test.
CHAPTER 3: Installation
15
The COS II can perform a number of self-tests that
check the memory, the LEDS, the DIP switches, the
ports, and the interrupt circuitry of the Switch.
More information about the self-tests is given in
Section 4.8.
For Set SWA 8
Normal operation OFF
Self-test ON
Sending or Suppressing Breaks
You can set the COS II either to pass break
characters along or to block them from reaching
your devices. SWB 8 controls this function.
