Page 19
Menu 3- Starter Settings
Ignition ON-OFF-ON-OFF-ON
Press & Release Program Button
Press Button #3
Setting 1 Special Door Lock/Unlock Operations (Factory Alarm Rearm).
1) Type 1 1 Flash/chirp Unlock before start. Lock pulse after start and on shutdown.
2) Type 2 2 Flashes/chirps Lock pulse ONLY after remote start shutdown.
*3) Type 3 3 Flashes/chirps Default Lock/ Unlock Pulses.
Press & Release the Program Button 1 Time (Setting 1) Confirmed with 1 LED flashes.
Press & Hold the Program Button until the appropriate # of park lights/siren chirps, then release.
Press & Release the Program Button to proceed to the next step.
Setting 2 14pin Connector- Gas/Diesel Mode (Blue wire on 14-pin)
1) (-) Input 1 Flash/chirp (-) Glow Plug input. Waits maximum 30 seconds then starts.
2) Time Delay 2 Flashes/chirps Waits for approximately 15 seconds then remote starts.
*3) Gas/ (+) Input 3 Flashes/chirps Waits 2 seconds to start if no diesel input is detected.
Press & Release the Program Button 2 Times (Setting 2) Confirmed with 2 LED flashes.
Press & Hold the Program Button until the appropriate # of park lights/siren chirps, then release.
Press & Release the Program Button to proceed to the next step.
Setting 3 Rearm Output (Yellow wire on 14-pin)
1) Type 1 1 Flash/chirp Pulse after start and with lock. (Provides Lock Pulse)
2) Type 2 2 Flashes/chirps Pulse after start only. (Provides Lock Pulse)
*3) Factory Re-arm 3 Flashes/chirps Pulse with lock and after starter shutdown.
Press & Release the Program Button 3 Times (Setting 3) Confirmed with 3 LED flashes.
Press & Hold the Program Button until the appropriate # of park lights/siren chirps, then release.
Press & Release the Program Button to proceed to the next step.
Setting 4 Run Time
1) 4 Minutes 1 Flash/chirp Runs for approximately 4 minutes when activated.
2) 45 Minutes 2 Flashes/chirps Runs for approximately 45 minutes when activated.
*3) 15 Minutes 3 Flashes/chirps Runs for approximately 15 minutes when activated.
Press&ReleasetheProgramButton 4 Times (Setting 4) Confirmed with 4 LED flashes.
Press & Hold the Program Button until the appropriate # of park lights/siren chirps, then release.
Press & Release the Program Button to proceed to the next step.
Setting 5 Maximum Crank Time
1) 10 Seconds 1 Flash/chirp 10 sec max time that the starter will stay engaged.
2) 3 Seconds 2 Flashes/chirps 3 sec max time that the starter will stay engaged.
*3) 5 Seconds 3 Flashes/chirps 5 sec max time that the starter will stay engaged.
Press & Release the Program Button 5 Times (Setting 5) Confirmed with 5 LED flashes.
Press & Hold the Program Button until the appropriate # of park lights/siren chirps, then release.
Press & Release the Program Button to proceed to the next step.
REMOTE VEHICLE STARTER/ALARM INSTALLATION MANUAL
