Menu 1- User Settings
..
.
continued from previous page
Setting 5 Active/Passive Locks
1) No Auto-Lock with Passive Arm 1 Flash/Chirp No auto-lock with passive arming
*2) Doors Auto-Lock with Passive Arm 2 Flashes/Chirps Doors Lock when passive arming
Press & Release the Program Button 5 Times (Setting 5) Confirmed with 5 LED flashes.
Press & Hold the Program Button until the appropriate # of park lights/ siren chirps, then release.
Press & Release the Program Button to proceed to the next step.
Setting 6 Sensor Enable/Disable
1) Sensor Disabled 1 Flash/Chirp Impact Sensor Disabled
*2) Sensor Enabled 2 Flashes/Chirps Impact Sensor Enabled
Press & Release the Program Button 6 Times (Setting 6) Confirmed with 6 LED flashes.
Press & Hold the Program Button until the appropriate # of park lights/ siren chirps, then release.
Press & Release the Program Button to proceed to the next step.
Setting 7 Passive/Active Arming
1) Passive Arming 1 Flash/chirp Auto Arms 30 seconds after last door is closed
2) Active Arming with Rearm 2 Flashes/chirps If unlock is pressed and no door is opened
*3) Active Arming 3 Flashes/chirps Arms with remote transmitter only
Press & Release the Program Button 7 Times (Setting 7) Confirmed with 7 LED flashes.
Press & Hold the Program Button until the appropriate # of park lights/ siren chirps, then release.
Press & Release the Program Button to proceed to the next step.
Setting 8 Auxiliary Outputs-26xx series only
1) Type 1 1 Flash/chirp Auxiliary outputs Activated
2) Type 2 2 Flashes/chirps Auxiliary output without unlock/ disarm
*3) No Auxiliary 3 Flashes/chirps Negative park light output
Press & Release the Program Button 8 Times (Setting 8) Confirmed with 8 LED flashes.
Press & Hold the Program Button until the appropriate # of park lights/ siren chirps, then release.
Press & Release the Program Button to proceed to the next step.
.
*(Default Settings)
Page 17
REMOTE VEHICLE STARTER/ALARM INSTALLATION MANUAL
