5
ATTIX 791-2M/B1
2.2 Operating elements
See fold-out page at the front of
these operating instructions.
1 Handle
2 Suction pipe support
3 Accessory holder
4 Applicance switch with
suction power control
5 Filter for air supply to motor
6 Retaining clamp
7 Tank locks
8 Dirt tank
9 Castor with brake
10 Inlet fitting
11 Appliance socket
12 Hose diameter setting
13 Cable hook
3 Before start-up
3.1 Assembling the cleaner
1. Open the retaining clamps
and lift off the upper section
of the cleaner.
2. Take the accessories out of
the dirt tank and the packag-
ing.
On delivery some of the accessories
are lying in the tank and must be re-
moved before the vacuum cleaner
is used for the first time.
Remove the upper section of the
vacuum cleaner:
The mains plug should not be in-
serted into a socket.
3. To pick up dust with maxi-
mum room concentration
values:
Insert the filter bag into the
dirt tank according to the
instructions (instructions in-
cluded).
To pick up harmless dust:
Insert the disposal bag (in-
structions included) into the
tank.
IMPORTANT: Press
the filter bag connection
firmly on to the inlet fitting.
4. Fit the upper section of the
vacuum cleaner and close
the retaining clamps.
NOTE: Ensure that the
retaining clamps fit properly.
4 Operation
4.1 Connections
4.1.1 Connecting the suction
hose
The suction hose
diameter must suit
the position of the
switch in order
to pick up dry,
nonflammable dust with maximum
room concentration values.
1. Connect the suction hose.
4.1.2 Electrical connection
The operating voltage shown on the
rating plate must correspond to the
voltage of the mains power supply.
Never use extension leads, cou-
plings and adapter when picking up
flammable dust.
1. Ensure that the vacuum
cleaner is switched off.
2. Insert the power cord into a
properly installed and fused
socket with an earthing con-
tact.
2 Description
2.1 Purpose
Depending on how hazardous
the dust is, the cleaner must
be fitted with appropriate filters.
See table in section 5.1.1.
