Bair Paws Model 875 Warming Unit Operator’s Manual
8
Check the 3M
TM
Bair Paws
TM
system website to ensure you have the most recent version of this document. www.bairpaws.com reorder #202391A
Mounting the Warming Unit on an IV Pole
CAUTION: To prevent tipping, mount the Model 875 warming unit on an IV pole at a
height that ensures stability. We recommend mounting the warming unit no higher than 44
in. (112 cm) from the oor on an IV pole with a minimum wheelbase radius of 14 in. (35.6
cm). Failure to do so may result in IV pole tipping, leading to potential catheter site trauma
and other patient injuries.
1. Position the IV pole-mount at the desired height on the IV pole.
2. Turn the clamp knob on the IV pole-mount clockwise to tighten the clamp to the pole.
3. Snap the warming unit into position by sliding the clip on the back of the warming unit
into the groove of the IV pole-mount. e assembly will click when the clip is fully
seated in the IV pole-mount.
IV pole-mount
Clamp knob
IV pole
Clip
