Zipper Mowers 309-355 Automobile Parts User Manual


 
www.Thunder-Max.com 309-360 Installation / Setup Guide V2009.04.23 ProductSupport@ZippersPerformance.com
5
Configuration], then double-click ‘Basic Settings’.
The basic pa settings ge opens. Check to see if the
[Speedo Cal] calibra tches ear and
model; if not, click th c alue as
shown, then click [Close].
Speedometer Calibration Settings
Step 4
Next is to configure the module for open or
closed loop operation (closed loop operation requires the
AutoTune module and wide band se aps
will initially open as ‘Closed Loop Configured’ by defau
lling the ‘Module’ settings
while the s. The
ap’ side is used to store the settings you desire the
ase map to dictate to the module. The ‘Module’ side,
ditable only when linked to the module, can be used
ter to override the map settings if desired.
tion setting ma
e button, enter the
your y
orrect v
nsors). Most m
lt.
To change or edit these settings, select [Configure]
[Closed Loop MODULE Settings] from the toolbar to
open the dialog page. This page is divided into two
e left side controhalves, th
right side controls the ‘Map’ setting
‘M
b
e
la
or closed loop (AutoTune) operation, click the ‘Closed
oop Processing’ box. For open loop operation, this box
hould not be not be checked (click checkmark to un-
heck). Close the window. Once linked, the system
etects if an AutoTune module exists on the bike and will
form you via screen message if there is a mismatch.
tep 5 Now you are ready to ‘Link’
nd ‘Write’ the map to the ECM.
ttach the communication cable
xhaust
Step 6 To link to the module, turn the key switch to the
“Ignition” position, making OFF”
rocker switch (Kill Switch) s is in
the “RUN” position. Select
martLink software. The button turns green to indicate
F
L
s
c
d
in
S
a
A
from your computer to the
ThunderMax module, making
certain that the cable is routed away
from any part of the motorcycle that
generates heat.
Special Note for International Model Bikes with
Active Exhaust Enabled: If your bike is equipped with
a working Active Exhaust Valve, you must unplug the
active exhaust harness before linking to the module, as
the AEV circuitry conflicts with the communication
stream. You can re-connect the harness after unlinking.
If the stock exhaust has been changed, disregard this
tep. ThunderMax does not support active es
certain the “RUN /
on the handlebar control
the “Link” Button in the
S a
successful link. Answer [No] to the “Do you wish to
READ the module map now” question at this time.
odule Maps and
that informs you
ent map in the
he map load.
ore performing this
From the toolbar, click [File] [Write M
Settings], answer OK to the message
that you are about to overwrite the curr
module; the transfer bar appears during t
Step 7 Verify Module Settings. Bef
step, clear any a
ctive Diagnostic Code readings. While
linked, from the Tuning Tree select [Module
Configuration] [Diagnostic Codes].
2004-2005 FXD 40960
2006-2007 FXD 45900
2007-up CVO 42450
Dyna®
2008-up FXD 42450
2001-2003 4352
2004-2006 40960
Softail
2007-up 42450
©
2002 4352
2003 20480
2004-2006 40960
Touring
2007-up (16”)
2007-up (17”)
42450
42000