Filter
Top Products
PERIODIC MAINTENANCE AND MINOR REPAIR
6-39
2
3
4
5
6
7
8
9
wheel has been removed together
with the brake disc, otherwise the
brake pads will be forced shut.
EAU25011
To install the front wheel
1. Install the speedometer gear unit
into the wheel hub so that the pro-
jections mesh with the slots.
2. Lift the wheel up between the fork
legs.
NOTE:
Make sure that there is enough space
between the brake pads before insert-
ing the brake disc and that the slot in
the speedometer gear unit fits over the
retainer on the fork leg.
3. Insert the wheel axle, and then in-
stall the axle nut.
4. Lower the front wheel so that it is
on the ground.
5. Tighten the axle nut to the speci-
fied torque.
6. Connect the speedometer cable,
and then install the speedometer
cable holder by installing the
screw.
7. Install the brake disc cover by in-
stalling the screws.
8. Install the engine guard by install-
ing the bolt.
1. Speedometer gear unit
1
1. Retainer
Tightening torque:
Axle nut:
85 Nm (8.5 m·kgf, 62 ft·lbf)
1