Filter
Top Products
Maintenance
50
F25ER 35.0 Nm (25.8 ft-lb) (3.57
kgf-m)
F25MH 35.0 Nm (25.8 ft-lb) (3.57
kgf-m)
F25TR 35.0 Nm (25.8 ft-lb) (3.57
kgf-m)
T25TR 40.0 Nm (29.5 ft-lb) (4.08
kgf-m)
Engine oil drain bolt:
F25EH 28.0 Nm (20.7 ft-lb) (2.86
kgf-m)
F25ER 28.0 Nm (20.7 ft-lb) (2.86
kgf-m)
F25MH 28.0 Nm (20.7 ft-lb) (2.86
kgf-m)
F25TR 28.0 Nm (20.7 ft-lb) (2.86
kgf-m)
T25TR 18.0 Nm (13.3 ft-lb) (1.84
kgf-m)
Engine oil filter:
18.0 Nm (13.3 ft-lb) (1.84 kgf-m)
EMU28222
Transporting and storing
outboard motor
WARNING
EWM00690
●
Leaking fuel is a fire hazard. When
transporting and storing the outboard
motor, close the air vent screw and fuel
cock to prevent fuel from leaking.
●
USE CARE when transporting fuel tank,
whether in a boat or car.
●
DO NOT fill fuel container to maximum
capacity. Gasoline will expand consid-
erably as it warms up and can build up
pressure in the fuel container. This can
cause fuel leakage and a potential fire
hazard.
WARNING
EWM00700
Never get under the lower unit while it is
tilted, even if a motor support bar is used.
Severe injury could occur if the outboard
motor accidentally falls.
CAUTION:
ECM00660
Do not use the tilt support lever or knob
when trailering the boat. The outboard
motor could shake loose from the tilt sup-
port and fall. If the motor cannot be trail-
ered in the normal running position, use
an additional support device to secure it
in the tilt position.
The outboard motor should be trailered and
stored in the normal running position. If there
is insufficient road clearance in this position,
then trailer the outboard motor in the tilt po-
sition using a motor support device such as
a transom saver bar. Consult your Yamaha
dealer for further details.
EMU28235
Clamp screw mounting models
When transporting or storing the outboard
motor while removed from a boat, keep the
outboard motor in the attitude shown.
ZMU02831