Filter
Top Products
Control functions
13
If the oil level warning indicator and the warn-
ing light come on, place the snowmobile on a
level surface and allow it to idle for one
minute.
If the oil level warning indicator and the warn-
ing light go off, the engine oil level is sufficient,
however it is getting low. Add engine oil as
soon as possible.
If the oil level warning indicator and the warn-
ing light do not go off, check the engine oil lev-
el in the oil tank (see page 49 for engine oil
level checking procedures), and add engine
oil if necessary.
ESU10512
Coolant temperature warning
indicator “”
If the engine overheats, the coolant tempera-
ture warning indicator and the warning light
come on. When this occurs, stop the engine
immediately and allow the engine to cool
down, and then check the coolant level in the
coolant reservoir. (See page 54 for checking
procedures.)
NOTICE
ECS00041
Do not continue to operate the engine if it
is overheating.
ESU12682
Self-diagnosis device
This model is equipped with a self-diagnosis
device for various electrical circuits.
If a problem is detected in any of those cir-
cuits, the warning light and the self-diagnosis
warning indicator will flash, and a two-digit er-
ror code will flash slowly in the tripme-
ter/odometer display. Note the error code,
and then have a Yamaha dealer inspect the
snowmobile as soon as possible. NOTICE:
Do not continue to operate the engine
longer than necessary if there is an error
code to avoid possible engine damage.
[ECS00820]
1. Oil level warning indicator “”
2. Warning light “”
1. Coolant temperature warning indicator “”
2. Warning light “”
U8GL11E0.book Page 13 Friday, June 20, 2008 6:51 PM