Yamaha FX10MTX Offroad Vehicle User Manual


 
Operation
37
2. Press the throttle lever slowly to move the
snowmobile.
3. Turn the handlebar in the desired direc-
tion.
4. Squeeze the brake lever to stop the
snowmobile.
5. Apply the parking brake by moving the
parking brake lever to the left.
FX10 / FX10RTR / FX10RTRA /
FX10MTR / FX10MTRA
WARNING
EWS00310
Make sure that the throttle lever is fully
released and the snowmobile is at a full
stop before shifting.
Be sure to slide the shift lever to FWD
or REV until it stops completely and
only while the engine is idling.
Make sure that the area behind the
snowmobile is clear before reversing.
Watch behind.
Reduce speed and avoid sharp turning
when operating the snowmobile in re-
verse.
1. To select the desired operating position,
pull the shift lever out, slide it to FWD or
to REV until it stops, and then push it
back in.
CAUTION:
ECS00070
Do not shift from FWD to REV or from
REV to FWD while the snowmobile is
moving. Otherwise, the drive system
could be damaged.
NOTE:
The reverse buzzer beeps while the shift lever
is in reverse.
2. Release the parking brake by moving the
parking brake lever to the right.
3. Press the throttle lever slowly to move the
snowmobile.
4. Turn the handlebar in the desired direc-
tion.
5. Squeeze the brake lever to stop the
snowmobile.
1. Pull out.
2. Slide to FWD (forward).
3. Push in.
1. Pull out.
2. Slide to REV (reverse).
3. Push in.
U8GL10E0.book Page 37 Friday, May 18, 2007 3:17 PM