Filter
Top Products
PERIODIC MAINTENANCE AND MINOR REPAIR
6-23
6
EAU00728
Rear brake pads
Each rear brake pad is provided with a
wear indicator, which allows you to
check the brake pad wear without hav-
ing to disassemble the brake. To check
the brake pad wear, check the position
of the wear indicator while applying the
brake. If a brake pad has worn to the
point that the wear indicator almost
touches the brake disc, have a
Yamaha dealer replace the brake pads
as a set.
EAU04098
Checking the brake and clutch
fluid levels
Insufficient brake fluid may allow air to
enter the brake or clutch systems, possi-
bly causing them to become ineffective.
Before riding, check that the brake fluid
is above the minimum level mark and
replenish if necessary. A low brake flu-
id level may indicate worn brake pads
and/or brake system leakage. If the
brake level is low, be sure to check the
brake pads for wear and the brake sys-
tem for leakage.
NOTE:
_
The rear brake fluid reservoir is located
behind panel F. (See page 6-8 for panel
removal and installation procedures.)
_
Observe these precautions:
●
When checking the fluid level,
make sure that the top of the brake
or clutch fluid reservoir is level.
●
Use only the recommended quali-
ty brake fluid, otherwise the rubber
seals may deteriorate, causing
leakage and poor braking or clutch
performance.
●
Refill with the same type of brake
fluid. Mixing fluids may result in a
harmful chemical reaction and
lead to poor braking or clutch per-
formance.
1. Brake pad wear indicator 1. Minimum level mark
Front brake
1. Minimum level mark
Recommended brake and clutch
fluid: DOT 4 brake fluid
Rear brake
E_5jw.book Page 23 Friday, March 30, 2001 2:14 PM