Filter
Top Products
Operation
35
again.
NOTE:
●
When the engine is cold, it needs to be
warmed up. For further information, see
page 35.
●
If the engine is warm and fails to start,
open the throttle slightly and try to start the
engine again. If the engine still fails to
start, see page 72.
EMU27670
Warming up engine
EMU27710
Manual start and electric start
models
1. After starting the engine, allow it to idle
for 3 minutes to warm up. Failure to do
so will shorten engine life.
2. Be sure the low oil pressure warning in-
dicator goes off after starting the engine.
3. Check for a steady flow of water from the
cooling water pilot hole.
CAUTION:
ECM00210
●
If the low oil pressure warning indicator
does not go off after the engine starts,
stop the engine. Otherwise serious en-
gine damage could occur. Check the oil
level and add oil if necessary. Consult
your Yamaha dealer if the cause for the
low oil pressure warning indicator can-
not be found.
●
A continuous flow of water from the pi-
lot hole shows that the water pump is
pumping water through the cooling
passages. If water is not flowing out of
the pilot hole at all times while the en-
gine is running, overheating and seri-
ous damage could occur. Stop the
engine and check whether the cooling
water inlet on the lower case or the
cooling water pilot hole is blocked.
Consult your Yamaha dealer if the prob-
lem cannot be located and corrected.
EMU27740
Shifting
WARNING
EWM00180
Before shifting, make sure there are no
swimmers or obstacles in the water near
you.
CAUTION:
ECM00220
To change the boat direction or shifting
position from forward to reverse or vice-
versa, first close the throttle so that the
engine idles (or runs at low speeds).
EMU27763
Forward (tiller handle and remote
control models)
Tiller control models
1. Place the throttle grip in the fully closed
position.
ZMU02034