Filter
Top Products
Operation
32
3. Place the throttle grip in the “”
(start) position.
4. Pull the manual starter handle slowly un-
til you feel resistance. Then give a
strong pull straight out to crank and start
the engine. Repeat if necessary.
5. After the engine starts, slowly return the
manual starter handle to its original po-
sition before releasing it.
NOTE:
●
When the engine is cold, it needs to be
warmed up. For further information, see
page 35.
●
If the engine is warm and fails to start,
open the throttle slightly and try to start the
engine again. If the engine still fails to
start, see page 72.
EMU27600
Electric start/prime start models
1. Place the gear shift lever in neutral.
NOTE:
The start-in-gear protection device prevents
the engine from starting except when in neu-
tral.
2. Attach the engine stop switch lanyard to
a secure place on your clothing, or your
arm or leg. Then install the lock plate on
the other end of the lanyard into the en-
gine stop switch.
WARNING
EWM00120
●
Attach the engine stop switch lanyard
to a secure place on your clothing, or
your arm or leg while operating.
●
Do not attach the lanyard to clothing
that could tear loose. Do not route the
lanyard where it could become entan-
gled, preventing it from functioning.
●
Avoid accidentally pulling the lanyard
ZMU02026
START
START
ZMU02335
ZMU02336
ZMU02304
N