Filter
Top Products
Operation
38
connect the fuel line if the outboard mo-
tor is equipped with a fuel joint.
Otherwise fuel may leak.
CAUTION:
ECM00990
● Before tilting the outboard motor, follow
the procedure under “Stopping engine”
in this chapter. Never tilt the outboard
motor while the engine is running. Se-
vere damage from overheating can re-
sult.
● To prevent the cooling water passages
from becoming frozen when the ambient
temperature is - 5°C or below, tilt the out-
board motor up after it has been
stopped 30 seconds or more.
EMU28005
Procedure for tilting up
Power trim and tilt models / power tilt models
1. Place the remote control lever / the gear
shift lever in neutral.
2. Disconnect the fuel line from the out-
board motor or close the fuel cock.
3. Press the power trim and tilt switch / pow-
er tilt switch “” (up) until the outboard
motor has tilted up completely.
4. Push the tilt support knob into the clamp
bracket or pull the tilt support lever toward
you to support the engine.
N
ZMU03196
N
ZMU04588
ZMU04602
UP
U6P212E0.book Page 38 Monday, June 6, 2005 4:23 PM