Filter
Top Products
To delete all manual locations:
1) When the unit is alerting a manual location,
press and hold Enter for more than 2 seconds.
The unit announces “user position deleted”
and displays “ADEL” . Press Enter again to
delete all manual locations.
If Enter is not pressed within 5 seconds after
“ADEL” is shown, the locations are saved and
the mode is exited.
17
OPERATION
18
Your unit is expertly engineered and designed
to exacting quality standards to provide you
with reliable, trouble-free operation. If your unit
has been correctly installed following the
guidelines in this manual, but is not operating
optimally, please refer to the troubleshooting
guide below.
PROBLEM: No display or audio.
Check fuse in Whistler plug; replace if
necessary with a 2 amp, 3AG type. Check fuse
for lighter socket; replace if necessary. Make sure
lighter socket is clean.
PROBLEM: Audio alerts are not loud
enough. Check audio level setting
(see
pg.10).
PROBLEM: Unit resets when vehicle hits
bumps.
Check for loose lighter socket; tighten
and clean. Check connections at both ends of
power cord. Substitute another cord to
determine if cord is defective. Return
defective cord to the factory.
If difficulties occur which cannot be solved by
information in this Troubleshooting Guide,
please call Whistler Customer Service at
or visit our FAQ page at
before returning your
unit for service.
TROUBLESHOOTING GUIDE
CARE & MAINTENANCE
During the summer months, avoid
prolonged exposure to direct sunlight by
removing your unit from the dash when your
vehicle is parked for an extended
period of time. Do not spray water,
cleaners, or polishes directly onto the unit.
The spray may penetrate through the
openings and damage the unit. Also, do not
use any abrasive cleaners on the unit’s
exterior.
19