Filter
Top Products
POP
™
Mode Alerts
Because POP
™
Mode radar utilizes the same
K or Ka band frequencies, POP
™
Mode Alerts will be
displayed as regular radar alerts.
LASER/RADAR ALERTS
Speed Radar Audio/Visual Alerts
When X, K or Ka is detected, the band ID and
signal strength are displayed. The audio alert is
continuous and has a geiger counter-like
pattern. The faster the beep, the closer or
stronger the radar source.
Laser Audio/Visual Alerts
When a laser signal is detected the audio alert is
continuous for a minimum of 3 seconds.
• The Displays Shows:
Pulse Protection
®
Pulse (or instant-on) radar is more difficult to
detect than conventional radar because it
remains ‘off’ until activated to measure the speed
of a targeted vehicle.
When a pulse type transmission is detected, your
Whistlerdetector sounds an urgent 3-second
audio warning and the display shows:
After the 3-second pulse alert, the standard alert
pattern continues for as long as the signal is
pr
esent.
It is important to respond promptly to a pulse
alert, since warning time may be minimal.
POP MODE ALERTS
Alert Priority
When two or more signals are received at the
same time, the alert priority is:
1. Laser
2. Speed Radar
3. Safety Radar
Example:
If X band is alerting, then suddenly a laser
signal is detected, the laser warning will
override the X band alert.
INTELLICORD
Intellicord
®
Ready
Using Whistler’s optional Intellicord
®
Power Cable
allows some models to control the detector’s fea-
tures such as Power On/Off, City Modes,
Dim/Dark, and Quiet/Auto Quiet with a simple
press of the button on the Power Cable. Two fea-
tures can be controlled: one by a short press of
the button, and the second by a long press of the
button. Option Mode allows the user to program
the feature assignments.
ALERT PRIORITY
Reset Features
All user features can be reset to factory settings.
•Unplug the Power Cord from the unit.
•Press and hold the Power and Quiet buttons.
•Plug the Power Cord into the unit.
•Wait for 2 beeps.
•Release the Power and Quiet buttons.
Unit is now reset to the following features
and settings.
Default factory settings are:
1.
S1: (For Intellicord
®
) Power ON or OFF.
2. S2: (For Intellicord
®
) Quiet feature.
3. ADIM: ON (Auto Dim ON).
4. HIGHWAY Mode.
5. Dim/Dark Mode to full illumination of display.
6. Auto Quiet Mode OFF.
7. Safety Radar OFF.
8. Vehicle Battery Saver ON.
9. Full Power Up sequence.
10. Default TONE 3.
11. All Bands ON.
12. Laser ON.
13. POP ON.
14. Voice ON.
15.
LED Periscope to BLNK.
RESET FEATURES
14 15
16