Filter
Top Products
Vehicle Battery Saver Mode
The Vehicle Battery Saver Mode automatically shuts
off your detector after 3 hours. The timer is reset if
the detector is turned off, unplugged or any button
is pressed before the timer has expired. The detec-
tor will alert you with an audible and visual warning
before it shuts off. During this warning, you can
momentarily reset the timer by pressing any button.
If the unit has automatically turned itself off, press
any button to turn the unit back on.
Refer to “Option Select Mode” for instructions
for deactivating battery saver mode feature.
Filter Mode
There are times when a radar detector can emit
the same frequency as police radar and can
cause your detector to falsely alarm. Sometimes
a detector can display a signal when picking up
another radar detector in vehicle close by. The
Whistler Filter Mode options provide a method
to study the signal which will verify if the signal
is a legitimate police radar or a false alert from
another detector. Three options exist:
Filter: Allows for normal filtering.
Filter 1: Pr
ovides and extra step to analyze the
legitimacy of the signal.
Filter 2: Provides 2 extra steps to analyze legiti-
macy of the signal.
Filter is the factory default and should provide
adequate filtering for most conditions. If you
experience excessive alerts due to radar detec-
tors in other vehicles, try the Filter 1 option. If
you continue to receive alerts from radar detec-
tors, use the Filter 2 option. Filter Mode does
not override Highway or City settings. See
Option Select Mode to change Filter settings.
OPERATION
Option Select Mode
Entering Option Select Mode allows you to customize
options such as Tone Select and Abbreviated Power Up
Sequence. Press the Menu button to enter Option Select
Mode. When selecting options, the Dark or Quiet buttons
must be pressed within 20 seconds or Option Select Mode
will automatically exit. To enter:
Press the Power button to exit Option Select Mode.
OPERATION
Stay Alert Feature
The Stay Alert Feature is designed to test a driver’s
alertness. To engage (when the unit is not alarming) :
• Press and hold the City button for approximate-
ly 2 seconds. Release the button during or imme-
diately after the alert is given. Display shows:
Within 30-60 seconds, two beeps are sounded;
to show alertness, the driver must press either the
City, Menu, or Quiet buttons within 3-5 seconds. If a
buttonis pressed within 3-5 seconds, the cycle is
repeated.
If a button is not pressed within 3-5 seconds, an
alarm sounds and the display shows:
• Press the Dark button to exit the Stay Alert feature.
WARNING!!! Stay Alert is NOT intended as a
substitute for adequate rest. You should NOT oper-
ate a vehicle if you are drowsy. During extended
periods of vehicle operation, you should take fre-
quent breaks. Improper reliance on the Stay Alert
feature may result in vehicle damage, personal
injury or death.
NEVER OPERATE A VEHICLE IF
YOU ARE DROWSY.
SWS
Safety Warning System™
In communities where transmitters are located,
the Safety Warning System
™
displays over 60
text messages. When Safety Radar is detected
the audio alert is geiger counter-like.
Safety Warning System Text
Example: Poor - Road - Surface.
Note: Not all areas have Safety Warning System
™
transmitters.
OPERATION
11 12 13