Filter
Top Products
OPERATION
11
OPERATION
Power On And Self-Test
Each time your Whistler detector is turned on, an auto-
matic self-test sequence confirms that the speaker and
visual displays are functional.
• Press Power or apply Power. Display reads:
Self-Test Display for 1750 Model
Memory/Beep Confirmation
All features selected (except Stay Alert and Quiet) are
retained in memory. Each time a button is pressed one
beep confirms feature “on”, two beeps confirm feature
“off”.
Audio Level Adjustment
The audio levels can be adjusted high to low, or low to
high, in eight steps: (0) is no audio level, (7) the highest,-(8)
for 1750
• Press Volume up to increase audio level.
• Press Volume down to decrease audio level.
As audio level is adjusted, beeps are provided and the
display indicates volume level. 1760, 1765 example shown:
Integrated Real Voice (1750 only)
When selected, Real Voice will be used to articulate the
following:
1.Band Identification
2.Safety Warning System messages
NOTE: In certain cases the voice message does not repli-
cate the text message.
3.Feature Selection
Compass Mode
The 1760/1765 is programmed from the factory in “Combo
Mode”. Combo mode means that the unit provides both
compass readings as well as detecting laser/radar signals.
Through the “Option Select Mode”, either laser/radar or
compass features can be turned off meaning, Radar equals
detection of all police bands and laser; Compass equals
no detection of police laser/radar.
Note: The unit must be calibrated to provide accurate
compass readings. See Compass Calibration Set-up sec-
tion on page 9.
10
1750/1760/1765 manual 3/6/02 2:20 PM Page 13